![]() ![]() ![]() If you wanted to use times instead of loadstep numbers, it would be a few extra lines to get the next time value but it is possible.Īlternatively, you could use a table, which allows the BFE command to apply values based on the time of the current loadstep. cnt = cnt + 1 ! Tracks loadstep number. It's a little convoluted to get the next *time* to be run but you could easily apply it to specific load steps by using a counter in your command snippet to track the loadstep. However, you can't do ranges you have options like "first," "last," "all," or by number, which lets you specify a loadstep.Īlternatively, if you like, you can make one command snippet that runs before all load steps and put a *if statement inside that checks the next time to be solved and then applies your commands if that time is within your range. In the command snippets in Workbench, you have the option of specifying which time points/loadsteps the command snippet will run before.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |